Register
Reply To Thread
  • 4/9/2018
HI,

Something has been going on for a while now. I have a bondtech extruder and when printing from the right side, the motor heats up to the point where I can melt a strand of filament by keeping it on the motor for a few seconds. The extreme heat melts the filament inside and makes it impossible to push through, leading to air prints. Any solutions? Some sort of mod like a heat sink?


Please help.

I didn't find the right solution from the Internet.

References:
http://forum.raise3d.com/viewtopic.php?t=2705
Thanks!

Reply To Thread